Overview
Each floor in Stitch has its own settings for grade level, wall thickness, and ceiling height. You can also overlay one floor on another to line them up. This article covers floor properties, measuring ceiling height, and the underlay floor view.
In This Article
- Floor Properties
- Adjust Ceiling Height and Enable Vertical Measuring
- Underlay Floor View
- Related Articles
Floor Properties
Left-click any floor title in the left-hand panel to open its properties:
- Above/Below Grade: Mark a floor as above or below exterior ground level (for example, a basement).
- Exterior Wall Thickness: Set the estimated wall thickness for the floor.
- Ceiling Height: Shown on the iGuide feature sheet (not on the 3D tour or floor plan).
Adjust Ceiling Height and Enable Vertical Measuring
- Choose a panorama with a clear, unobstructed view of a flat wall about 4 ft (120 cm) away.
- Switch to Move mode.
- Double-click the top of the wall in the panorama preview. A red cross appears.
- Double-click the bottom of the wall in the panorama preview.
- Save the measurement as the floor's ceiling height.
Note: A new measurement overwrites the previously saved value. You can also enter ceiling height manually under the floor's Settings.
Underlay Floor View
The underlay shows another floor beneath the current one, which helps you line up floors. Reference lines from the Drawing Tool stay visible across floors in this view.
- Right-click the floor name in the tree view (left panel).
- Select Set underlay floor.
- Choose another floor to overlay, or select None to turn it off.
Comments
0 comments
Please sign in to leave a comment.