Uploading Stitch Data

This article will explain how to upload Stitch data to the Portal so that your data can be drafted.

Step-By-Step Instructions

To upload Stitch data for drafting, follow the steps below:

1. Once the iGUIDE has been exported from Stitch, go into the project folder, then into the _Export folder.

2. Inside the _Export folder, will find the .TAR file, this is the file that will be uploaded to the Portal for drafting.

3. Find the address on the Portal (assuming it has already been created) and:

   1. Click Upload Stitch Data (refer to Figure 1)

   2. Choose the iGUIDE and click Stitch Data under Operator Actions from the tabs on the left-hand side of the page (refer to Figure 2).

Figure 1 - Upload Stitch Data

Figure 2 - Upload Stitch Data on the iGUIDE

1. Click the dashed line box and select the .TAR file or drag and drop the .TAR file into the dashed line box. See Figures 3 & 4 for examples.

Figure 3 - Dragging a .TAR file for upload

Figure 4 - Browsing for the .TAR file

1. Once the file has been selected, click the blue Upload button at the bottom of the screen.

2. After clicking Upload

   1. A progress bar will appear.

   2. When it turns green and shows 100% this means that the file has been successfully uploaded. Refer to Figure 5.

Figure 5 - Successful upload to the Portal

1. If you upload the wrong .TAR file by mistake,

• Simply click the Delete stored file button(1)

• You can also confirm the Stitch & Survey versions here (2). See Figure 6.

Figure 6 - Deleting stored data

NOTE: You can not delete the stitch data once the iGUIDE has been published.